Switch# show startup-config Why does the switch respond with startup-config is not present? Karena belum konfigurasi belum disimpan. Part 2: Create a Basic Switch Configuration Step 1: Assign a name to a switch. To configure parameters on a switch, you may be required to move between various configuration modes. I read in book that it has to be there initially when you get new router unless someone removed configuration file from NVRAM. Show more When I go to enable mode and type sh run I see the config file in router RAM exist but when I type sh start I get startup-config is not present meaning NVRAM don't have it.
.This lab is about 6.4.1.3 Packet Tracer – Configure Initial Router Settings. In this tutorial we will discuss about 6.4.1.3 Packet Tracer answers, in last tutorial we discuss about Introduction to.6.4.1.3 Packet Tracer Answer6.4.1.3 Packet Tracer – Configure Initial Router SettingsHere we have topology of 6.4.1.3 Packet Tracer – Configure Initial Router Settings. Equipment’s which we required are as follows. 1 Router.
Run Command For Startup Config
1 PC6.4.1.3 Packet Tracer Lab ObjectiveWe have few objectives of this lab which we have to do. Verify the Default Router ConfigurationStep 1: Establish a Console cable Connection to R1. Choose a Console cable from the available connections. Click PC-A and select RS 232.
Click R1 and select Console. Click PC-A Desktop tab Terminal. Click OK and press ENTER. You are now able to configure R1.Step 2: Enter privileged mode and examine the current configuration.Enter into the Router 1 Privileged mode by the following commands and them examine the current configurations of the router.Enable the command use to Enter into the privileged EXEC mode. Save the Running Configuration File Step 1: Save the configuration file to NVRAM.You have configure the initial settings for R1. Now back up the running configuration file to NVRAM to ensure that the changes made are not lost if the system is rebooted or loses power.What command did you enter to save the configuration to NVRAM?
Startup-config Is Not Present Why Does This Message Appear
Copy running-config startup-configWhat is the shortest, unambiguous version of this command? Copy r sWhich command displays the contents of the NVRAM? Show startup-configuration or show startVerify that all of the parameters configured are recorded. If not, analyze the output and determine which commands were not done or were entered incorrectly. You can also click Check Results in the instruction window.